EN 10025-5:2004 (E)
7.7 Dimensions, tolerances on dimensions and shape, mass
7.7.1 Dimensions, tolerances on dimensions and shape shall be in accordance with the requirements given in the order by reference to the relevant document according to 2.2 and according to 2.2 and 7.7.1 of EN 10025-1:2004.
For hot rolled plate tolerances the basic requirements shall be in accordance with EN 10029, including thickness tolerances to class A, unless otherwise agreed at the time of the order. See option 18.
For plates cut from continuously hot rolled strip, the thickness tolerances shall be in accordance with EN 10051. 7.7.2
The nominal mass shall comply with EN 10025-1.
8 Inspection
8.1 General
The products shall be delivered either with specific or non-specific inspection and testing to indicate compliance with the order and this document (see 5.1).
8.2 Type of inspection and inspection document
The type of inspection and inspection document required shall comply with EN 10025-1. See option 9.
8.3 Frequency of testing
8.3.1 Sampling
The verification of the mechanical properties shall be carried out by cast. 8.3.2 Test units
8.3.2.1 The test unit shall contain products of the same form, grade and quality, delivery condition and of the same thickness range as specified in Table 4 for the yield strength and shall be 40 tonnes or part thereof.
8.3.2.2 If specified at the time of the order for flat products of quality J2 and K2 the impact properties only or the impact properties and the tensile properties shall be verified out of each parent plate or coil. See option 13. See option 14.
8.3.3 Verification of chemical composition
The verification of the chemical composition shall be in accordance with EN 10025-1. See option 2.
8.4 Tests to be carried out for specific inspection
8.4.1
The following tests shall be carried out:
12