EN10025-5-2005(8)

EN 10025-5:2004 (E)

1 Scope

Part 5 of this document, in addition to part 1, specifies requirements for flat and long products of hot rolled steels with improved atmospheric corrosion resistance in the grades and qualities given in Tables 2 and 3 (chemical composition) and Tables 4 and 5 (mechanical properties) in the usual delivery conditions as given in 6.3.

The thicknesses in which products of the steel grades and qualities specified in this document may be supplied are given in Table 1.

In addition to EN 10025-1:2004 the steels specified in this document are especially intended for use in welded, bolted and riveted components which shall have enhanced resistance to atmospheric corrosion, for service at ambient temperatures (subject to the restrictions described in 7.4.1).

The steels specified in this Part 5 are not intended to be heat treated except products delivered in the delivery condition +N. Stress relief annealing is permitted (see also the NOTE in 7.3.1.1 of EN 10025-1:2004). Products delivered in +N condition can be hot formed and/or normalized after delivery (see Clause 3).

2 Normative references

The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.

2.1 General standards

EN 10020, Definition and classification of grades of steel.

EN 10025-1:2004, Hot rolled products of structural steels - Part 1: General technical delivery conditions. EN 10027-1, Designation systems for steels - Part 1: Steel names, principal symbols. EN 10027-2, Designation systems for steels - Part 2: Numerical system.

EN 10163-1, Delivery requirements for surface condition of hot-rolled steel plates, wide flats and sections – Part 1: General requirements.

EN 10163-2, Delivery requirements for surface condition of hot-rolled steel plates, wide flats and sections – Part 2: Plates and wide flats.

EN 10163-3, Delivery requirements for surface condition of hot-rolled steel plates, wide flats and sections – Part 3: Sections.

EN 10164, Steel products with improved deformation properties perpendicular to the surface of the product - Technical delivery conditions.

EN 10221, Surface quality classes for hot-rolled bars and rods - Technical delivery conditions. CR 10260, Designation systems for steels - Additional symbols.

5